It will not create a shortcut on your desktop, so navigate to it by going to: Step 3: Configure Epson Printer on your network Follow the onscreen directions to complete the installation. Locate and open the Epson-TMConfig installer that was downloaded to your computer. Once logged in, click on the Downloads tab, locate the Epson-TMConfig installer, and download it to any computer on the same network as your Epson Printer. Step 2: Download & Install Epson Config Softwareĭownload the Epson IP Configure Tool (Windows): Epson_TMConfig.zip If a status sheet prints out, then you have completed this step. The self test can take 10-20 seconds before it starts printing. Then holding the feed button while powering back on. Connect the power supply cable to the printer.īefore you start it is suggested to perform a self test on the printer by powering down.Again, you should hear a distinct click when it plugs in. Plug the other end of the Ethernet cable directly into your network switch/hub/router.You should hear a distinct click when it plugs in. Connect the cable into the ‘Ethernet Interface Connector” as labeled in the above diagram. Plug one end of the Ethernet cable into the back of the Epson printer.The following steps should be performed from a workstation and NOT the DVMAX Server computer. The following images represent the TM-T88V and TM-T20. Before installing the printer it is important to be familiar with the back panel of the printer, the card ports, reset switch, and indicator LEDs.
0 Comments
Leave a Reply. |